Brinkmann Solar Garden Accent Lights Landscape Lighting دليل المستخدم

Brinkmann Solar Garden Accent Lights Landscape Lighting دليل المستخدم لجهاز

Brinkmann Solar Garden Accent Lights Landscape Lighting دليل المستخدم

ومقتطفات من محتويات

محتوى موجز على الصفحة لا 1

EXTRA-LONG RUNNING SOLAR POWERED L.E.D. GARDEN ACCENT LIGHTSEMPEROR™ OWNER’S MANUALASSEMBLY AND OPERATING INSTRUCTIONS

محتوى موجز على الصفحة لا 2

HOW YOUR EMPEROR™SOLAR-POWERED L.E.D. LIGHTS WORKREAD AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE OPERATING YOUR SOLAR LIGHT.SAVE THIS MANUAL FOR FUTURE REFERENCE.IMPORTANT: The EPA Certified RBRC® BatteryRecycling Seal on the nickel-cadmium (Ni-Cd)battery contained in our product indicates TheBrinkmann Corporation is voluntarily participatingin an industry program to collect and recyclethese batteries at the end of their useful life,when taken out of service in the United States orCanada. T

محتوى موجز على الصفحة لا 3

ASSEMBLY INSTRUCTIONSInspect contents of the box to ensure all parts are included and undamaged.A flathead screwdriver is required formounting the wall bracket.1PARTS LIST:1 Emperor Light Head Fixture2 Ground Stake3 Connector w/Point4 Deck/Wall/Fence Mounting Bracket5 Mounting Screws (2)52Select a location with full, direct sunlight.Shady locations will not allow the battery tocharge fully and will reduce the hours ofnighttime light.NOTE:43The rechargeable Ni-Cd batterymust be allowed to fully c

محتوى موجز على الصفحة لا 4

Step 1Attach the ground stake to a pointedconnector. Push approximately 3" of theground stake into the ground. If theground is too hard, soak area with waterto soften.Step 2Insert light head into ground stake. Thephotocell light sensor should point awayfrom other nighttime light sources.Step 3Charge in direct sunlight for 10-12 FULL,SUNNY DAYS. The light will turn onautomatically at night. Allow at least10-12 cycles (i.e., 10-12 days and nightsof charging and discharging) for thebattery to charg

محتوى موجز على الصفحة لا 5

DECK/WALL/FENCEMOUNTING:Select a location with full, direct sunlight.Shady locations will not allow the battery tocharge fully and will reduce the hours ofnighttime light.Step 1Mount the bracket to a deck, wall orfence using the two screws provided.Step 2Insert light fixture with connector intobracket. The photocell light sensorshould point away from other nighttimelight sources.Step 3Charge in direct sunlight for 10-12 FULL,SUNNY DAYS. The light will turn onautomatically at night. Allow at leas

محتوى موجز على الصفحة لا 6

Changing BatteryStep 1Remove lens from top housing byturning lens clockwise.Step 2With top housing upside down (solarpanel facing down), push batterycompartment tab and lift off batterycompartment lid.IMPORTANT: The EPA Certified RBRC® Battery Recycling Seal onthe nickel-cadmium (Ni-Cd) battery contained in our productindicates The Brinkmann Corporation is voluntarily participatingin an industry program to collect and recycle these batteries atthe end of their useful life, when taken out of ser

محتوى موجز على الصفحة لا 7

Solar lights can be left outside year round, even in cold weather. However, if youwish to store your light indoors for more than two or three days, follow these stepsto prevent damage to rechargeable batteries:•Store at room temperature in a dry location.•Store solar light where it can receive some sunlight or room light each day.The battery needs light to maintain a charge during storage.•During prolonged storage, units must be fully discharged and charged onceevery month or remove batter

محتوى موجز على الصفحة لا 8

1-YEAR LIMITED WARRANTYFor 1-year from date of purchase, The Brinkmann Corporation warrants the Emperor solar light against defects due to workmanship ormaterials to the original purchaser. The Brinkmann Corporation’s obligations under this warranty are limited to the following guidelines:•This warranty does not extend to the L.E.D. or battery.•This warranty does not cover solar lights that have been altered or damaged due to: normal wear, abuse, improper maintenance,improper use, disassem

اترك التعليق